Racelogic USER GUIDE Manual do Utilizador descarregar pdf (Página 8)

Page | 8 Revision 1.4 15 January 2015

Menu Layout

File

→ Info - Display file info for selected file.

→ Delete – Delete selected file Yes/No.

→ Format SD/USB – Erase and Format SD/USB Yes/No.

Constellation

→ GPS/GAL – Tick to select GPS/Galileo constellation for recording.

→ GLONASS – Tick to select GLONASS constellation for recording.

→ BeiDou – Tick to select BeiDou constellation for recording.

→ 2Bit – Record with 2bit quantisation when single constellation is selected.

Play

→ Loop – selected file will replay continuously.

→ Pause Time – Defines the pause time between each replay.

→ From – Specify a time in the scenario to replay from.

→ For - Specify how long the scenario will replay for.

Record

→ For - Specify how long the LabSat 3 will record for.

Setup

→ Display – Adjust display contrast and backlight brightness.

→ RF Test – Outputs RF test signal.

→ Power Save – When selected, will power down display backlight and internal monitor during recording.

→ CLK REF

→ Internal - As the default setting LabSat 3 will use it internal reference clock.

→ External 10MHz – Allows the user to connect a 10MHz reference signal on the REF input.

→ Time – Configure internal clock using UTC time from internal GNSS monitor or set manually.

→ LAN

→ DHCP – Enable/Disable DHCP.

→ IP Address – Set the IP address assigned to LabSat 3.

→ SUBNET MASK - Set the Subnet mask assigned to LabSat 3.

→ DEFAULT GATEWAY - Set the default gateway for the network.

→ Digital

→ CH1

→ 1PPS – Record 1PPS signal from internal GNSS monitor (disable power save).

→ RS232 – Record RS232 signal.

→ CAN CH1 – Record CAN Bus channel 1.

→ DIGI – Record state of DIGI input signal.

→ CH2

→ 1PPS – Record 1PPS signal from internal GNSS monitor (disable power save).

→ RS232 – Record RS232 signal.

→ CAN CH2 – Record CAN Bus channel 2.

→ DIGI – Record state of DIGI input signal.

CAN

→ Record Type

→ Digitize – When selected the CAN data will be digitized and integrated into the .LS3 file.

→ Log File – When selected the CAN data will be logged into a separate .txt file.

→ CH1

→ Baud rate – Enables the user the set the desired baud rate.

→ Silent Record - Determines whether or not the LabSat sends an acknowledge pulse during

recording.

→ CH2

→ Baud rate – Enables the user the set the desired baud rate.

→ Silent Record – Determines whether or not the LabSat sends an acknowledge pulse during

recording.

About – Contains information specific to the LabSat e.g. serial number & firmware version.

Exit – Return to file list.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 26 27

Comentários a estes Manuais

Sem comentários

Racelogic USER GUIDE Manual do Utilizador Página 8

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de navegação Racelogic USER GUIDE