Racelogic VBOX II Guia do Utilizador descarregar pdf (Página 21)

Racelogic Ltd Lap Timing Mode

02/05/2014 Page 21

 The screen will count down from 5 to 1 after it reaches 1 the following screen will appear:

 When this screen shows you can then start your lap. Timing of your lap will start as soon as

you pull away and will then stop as you cross the start / finish line at the end of your flying

lap.

Start / finish and split lines

Before PerformanceBox can measure and display times, you will need to either load previously

recorded start / finish lines or create new ones in your PerformanceBox. This is done using either

Simple Lap Timing, mentioned above, which sets only a start / finish line. In order to set a start /

finish AND split points, follow the instructions below.

Setting start / finish lines

1. Press the MENU button to display the Lap Timing Menu.

2. Highlight ‘SET START & SPLITS’ and press OK

3. As you drive across the start / finish line press OK

4. This will set the start / finish line and the screen will now show the SET SPLIT1 screen.

5. To set the first Split, press OK when you pass this point or press RESET to skip.

6. If you wish just to place a separate Finish line, press the ‘RESET’ button to skip all the split

points and scroll to the SET 2

FINISH screen.

7. Press OK to set a separate finish line as you drive over it.

Note: you must be moving to be able to set virtual lines.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 71 72

Sem comentários

Racelogic VBOX II Guia do Utilizador Página 21