Racelogic VBOX II Guia do Utilizador descarregar pdf (Página 29)

Racelogic Ltd Power Mode

02/05/2014 Page 29

Begin to accelerate, and press OK. Continue to accelerate to the top of the engine rev range.

At the top of the rev range, disengage the clutch and put the gearbox into neutral. Once

deceleration has begun the screen will display the recording information:

Let the vehicle coast down to a speed a long way below the speed at which maximum power is

likely to occur, then accelerate briefly to finish the run:

Press OK to save the losses; pressing RESET will cancel the recorded losses so that you can start

the process again. Losses are permanently saved, but you should generally carry this out on the

same piece of road in the same direction as your acceleration runs. Note any small gradient can

have a large effect on the measurement.

If you have not carried out any power tests at this point then accessing the Power Run screen will

simply display the priming instructions. If you have already carried out power runs the results will

now be displayed as output from the flywheel rather than the wheels. Any further power runs will

display the results at the flywheel, until the RESET button is pressed when in the Losses Run

screen.

Pressing the RESET button when in the Power Run screen will clear the result in order for a new

run to commence.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 71 72

Sem comentários

Racelogic VBOX II Guia do Utilizador Página 29