Racelogic USER GUIDE Manual do Utilizador descarregar pdf (Página 59)

RACELOGIC Traction Control Manual V3.0

Page 59

5.4 Sensor Gapping

The sensor will work up to a range of 2mm. Try to gap the sensor to 1.5mm away

from the pickup point, this will allow for any movement.

Power up the traction control System and keep moving the sensor closer until the

LED on the sensor is illuminated.

NOTE – If you are picking up from a wheel hub etc, it is very important that the gap

on the sensor does not move when the car is under hard cornering. This could

cause the gap to either close up or open up. This could cause the sensor to drop out

and the traction control to stop working correctly.

5.5 Sensor Checklist

• LED on the sensor must be illuminated.

• Sensor face must be at

90°

to the surface.

• Over one revolution, the sensor to plate distance must not vary more than

±0.5mm

5.6 Running Wheel speed Wires

It is very important that the wires marked with each corner of the vehicle are

connected to the sensors in those corners. The system will not work if this is

done incorrectly

The system is programmed at the factory to reflect these settings. Orientation will be

as the driver sits in the vehicle. See Diagram 13.

Diagram 13 - Wheel speed Orientation

FRONT RIGHT FRONT LEFT

REAR RIGHT REAR LEFT

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 65 66 67

Sem comentários

Racelogic USER GUIDE Manual do Utilizador Página 59