Racelogic USER GUIDE Manual do Utilizador descarregar pdf (Página 60)

RACELOGIC Traction Control Manual V3.0

Page 60

5.7 Connecting Sensors

Once the sensors have been fitted each of the four wires must be run to the sensors.

Each wire has two cores with red and blue shielding. Connect each wire to the

sensor as follows.

• Run each wire to the sensors.

• Place a length of Heat shrink over the wire.

• Strip back the insulation exposing the two cores.

• On the red wire crimp the female contact, and on the blue wire crimp the male.

• Push the crimps into the Sure Seal (waterproof rubber connector that comes with

the sensors), red to pin 1 and blue to pin 2, ensuring they are pushed all the way

in.

• With a heat gun shrink down the heat shrink.

Sure-Seal Pin TC Colour Sensor Colour

1 Red White

2 Blue (GND) Black

5.8 Programming the PPR (pulses per revolution)

The traction control will need to be programmed for the amount of pick up points that

are being used.

Once these have been changed and downloaded to the unit, the system will need to

be powered down for the box to register the changes.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 66 67

Sem comentários

Racelogic USER GUIDE Manual do Utilizador Página 60